How Do Solar Cells Work
How Solar Cells Are Made

Applications
Panel Matrix
General Spec

Solar Modules Key Selling Points
Cost Optimization

Limited Warranty for
Photovoltaic Module


How Do Solar Cells Work?

To understand the operation of a PV cell, we need to consider both the nature of the material and the nature of sunlight. Solar cells consist of two types of material, often p-type silicon and n-type silicon. Light of certain wavelengths is able to ionize the atoms in the silicon and the internal field produced by the junction separates some of the positive charges (“holes”) from the negative charges (electrons) within the photovoltaic device. The holes are swept into the positive or p-layer and the electrons are swept into the negative or n-layer.

Although these opposite charges are attracted to each other, most of them can only recombine by passing through an external circuit outside the material because of the internal potential energy barrier.

Therefore if a circuit is made (see figure 3) power can be produced from the cells under illumination, since the free electrons have to pass through the load to recombine with the positive holes.

The amount of power available from a PV device is determined by:
• the type and area of the material;
• the intensity of the sunlight; and
• the wavelength of the sunlight

Single crystal silicon solar cells, for example cannot currently convert more than 25% of the solar energy into electricity, because the radiation in the infrared region of the electromagnetic spectrum does not have enough energy to separate the positive and negative charges in the material.


• Polycrystalline silicon solar cells have an efficiency of less than 20% at this time and amorphous silicon cells, are presently about 10% efficient, due to higher internal energy losses than single crystal silicon.

• A typical single crystal silicon PV cell of 100 cm2 will produce about 1.5 watts of power at 0.5 volts DC and 3 amps under full summer sunlight (1000Wm-2). The power output of the cell is almost directly proportional to the intensity of the sunlight. (For example, if the intensity of the sunlight is halved the power will also be halved).

• An important feature of PV cells is that the voltage of the cell does not depend on its size, and remains fairly constant with changing light intensity. However, the current in a device is almost directly proportional to light intensity and size. When people want to compare different sized cells, they record the current density, or amps per square centimeter of cell area.

• The power output of a solar cell can be increased quite effectively by using a tracking mechanism to keep the PV device directly facing the sun, or by concentrating the sunlight using lenses or mirrors. However, there are limits to this process, due to the complexity of the mechanisms, and the need to cool the cells. The current output is relatively stable at higher temperatures, but the voltage is reduced, leading to a drop in power as the cell temperature is increased.

• Other types of PV materials which show commercial potential include copper indium diselenide (CuInSe2) and cadmium telluride (CdTe) and amorphous silicon as the basic material.

 

 

   
   

Contact Us

©2013 Picker Solar All Rights Reserved